Firmware

Flashing MeshCore to the WisMesh Pocket V3

Follow the instructions below to flash MeshCore to your WisMesh Pocket V3.

Why This Guide?

The WisMesh Pocket V3 uses a different display driver than earlier versions, so firmware that supports it isn't available on the official MeshCore flasher yet. Support is expected there soon.

If you don't want to wait, follow the instructions below. They use a firmware file that includes the new display driver for the V3.

Step-by-Step Instructions

  1. Connect your device to your computer using a USB data cable.
  2. Download the FLASH_ERASE file and take note of where it was saved.
    Download FLASH_ERASE (.uf2)
  3. Download the firmware file and take note of where it was saved.
    Download Firmware (.uf2)
  4. Quickly double-press the reset button (twice within about half a second) to enter DFU mode.
  5. Look for a new USB drive appearing on your computer. It may be named after your board.
  6. Copy or drag the downloaded FLASH_ERASE_nrf52_softdevice_v6.uf2 file onto that drive.
  7. Wait for the device to reboot automatically. Do not disconnect it while the file is being copied.
  8. After the device has rebooted, quickly double-press the reset button (twice within about half a second) to enter DFU mode again.
  9. Copy or drag the downloaded RAK_4631_companion_radio_ble-PR3651.uf2 file onto that drive.
  10. Enjoy MeshCore on your WisMesh Pocket V3!